Hi mates
Hope I can get some advice to help me trouble shoot a FF build, I'm kind of painting by numbers here copying the layout of an ivor by Dustin Francis as my guide.
Its a freaken mess at the moment so Im too embarrassed to show it to you just yet and I've very rudimentary understanding of electronics so sorry in advance for stupid questions.
So, after carefully going over the wiring I'm almost 100 percent that it’s wired up right, when I plug in i get signal into my amp but seeming nothing when I click it on. If i turn my amp up loud there is a bit of crunchy signal coming through (not good crunch). Could it be the pots are wired up around the wrong way thus not enough juice getting through? at the moment I have 500k for the vol 1k for fuzz. Is that right? Im open to other suggestions
Edit - 1k for vol and 500k fuzz is correct I’m pretty sure
Thanks guys and gulls
Andrew
Fuzz Face build trouble shoot
Moderator: The Captain
- squarewave
- Posts: 1167
- Joined: Wed Aug 27, 2008 3:20 am
Fuzz Face build trouble shoot
Insta @drewcifer01 @lavafangs @andrew_sings_solo
- jerms
- Posts: 5629
- Joined: Sun Mar 01, 2009 10:39 pm
- Location: back in the basement!!
Re: Fuzz Face build trouble shoot
1K is for the attack/fuzz control...
Who is online
Users browsing this forum: No registered users and 8 guests